American Car Craft Corvette Taillight Grilles Laser Mesh "Racing Flag 4Pc Polished 2005-2013 C6 all" - Manual (Page 2)

1 .Thoroughly scrub clean the perimeter of all four taillights. This is a critical step to
insure a good long term bond. Once this is done swipe the perimeter with the adhesive
promoter tube supplied with your kit.
2. (DO NOT SCRATCH YOUR PAINT!! you may elect to put some masking tape on your
painted surface area) set each taillight cover in place and check the overall shape. Your
new grills come to you preformed to match your taillights however it will be necessary
to further shape each grill by hand in order to achieve the best contoured fitment. Once
you have shaped the grills simply peel the red release liner from the back of the grill and
then carefully set them in place pressing firmly along the outer perimeter to set the
bond. Go over the perimeter several times with high pressure and allow 24hrs to
complete the bond.
3. Remove the protective liner. NOTE: You have been supplied with five strips of ¼
chrome trim. This trim is optional. If you take a close look at the taillight lenses before
installation you will notice an irregular perimeter gap of the factory lenses. This gap is
almost undetectable with the factory lenses in place but after applying you new grills
this irregularity will become more apparent. We have supplied this chrome trim to
eliminate this gap. If you elect to use this trim, simply apply a thin bead of adhesive
promoter supplied with the trim to the painted surface directly in front of the grills
perimeter. Then peel the release liner from the trim and apply the trim directly to the
paint nice and tight against the grill. Start at one side of the lens screw tab and work
your way around to the other side and then cut the trim to fit against the tab for the
remaining side. You have been supplied with a fifth strip in the event you may ever have
to change a bulb. The extra trim is added for replacement.
IMPORTANT TECH NOTE: Be sure to allow the top of the new grills to set behind the lens
attachment screw in order to allow removal of the lens.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com