American Car Craft Chrysler 300 ONLY Fog Light Polished Billet Style 2005-2010 - Manual (Page 2)

4. Once the hole has been successfully prepared simply peel the red release liner
from the back of the grille and set it into position pressing firmly to set.
5. You have been supplied with two lengths of chrome trim. This trim has been
provided to be applied to the outer edge of the fog light hole directly to the paint
and up against the new grille you just installed to complete the installation. (What
you are doing is installing the stainless cover in between the two strips of
molding) Begin by removing the red release liner from the back of the chrome
trim then starting at the top center of the ridge and work the trim around the ridge
to the start point. Trim off the excess with a scissor but leave a little extra so that
you will have to buckle the ends together into a nice tight butt seam. Do not get
wet for 24 hours.
6. Repeat steps 1-5 for the opposite side.
If any questions occur during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.