American Car Craft HHR Eyelid Kit Chrome ABS 2006-2012 - Manual (Page 2)

2. Please refer to pictures as you continue thru steps 2 and 3. Place the new cover
over the headlight so that it fits along the upper edge of the headlight and
make note of its position. If positioned correctly you will have about a 1/4”
space between the edge of the eyebrow and the edge of the light. NOTE: This
space will be covered by the chrome trim in the following steps. Once you have
a good position draw the position directly to the headlight with a fine marker.
Also add 2 vertical lines crossing over the new cover onto the headlight. These
marks will give you accurate placement. Now you may begin permanent
installation by peeling the release liner from the underside and carefully
reposition the new cover at the placement marks you just applied and work
the new cover onto the headlight using the hard plastic squeegee provided
press down on the cover nice and evenly to attach it without any air pockets.
Remove the protective liner.
3. You have been provided with a length of chrome trim. This trim is designed to
cap the headlight cover you just installed and to border the entire headlight.
Apply a small bead of the adhesive promoter from the tube (provided) around
the edge of the headlight. Then begin placing the trim starting at the bottom
center edge of the headlight. Work your way around to the start point pulling
the red release liner as you go. As you approach each corner pre-bend the trim
between your fingers and your thumb so that the trim takes the shape of each
corner without forcing. Once you come to the start point mark the overlap
slightly longer then trim the molding on the mark with a pair of scissors. Buckle
the two ends together and press firmly to set a nice tight seam. Press the
entire trim to permanently set. Repeat steps 1-3 for opposite side. TECH TIP:
Use a little instant adhesive at the butt seam to eliminate separation or
shrinkage of the molding over time.
DO NOT GET WET FOR 24 HOURS.
IF ANY QUESTIONS OCCUR DURING INSTALLATION PLEASE CONTACT AMERICAN CAR
CRAFT AT 727-861-1500.
Thank You and Enjoy Your New Purchase!