American Car Craft Mustang Doorsills Polished w_ Brushed Stainless Tops 4Pc ETCHED MUSTANG V6 & GT 2005-2009 User Manual
Page 2
2. Once your surface is properly prepared place the new outer doorsill into position
and make note of its position at this time also check to see if any minor
adjustments need to be made so that your doorsill conforms to the shape of the
factory sill. PLEASE REFER TO PICTURE FOR PROPER SILL PLACEMENT. If
adjustments are necessary simply form by hand so that your new sill fits into the
factory doorsill without forcing. Once you have achieved a nice contoured fit
simply remove the release liner from the attachment tape on the underside of
the sill and firmly press into position.
3. You have been provided with a length of fine chrome trim. Use this trim to close
the gap at the top edge of the new stainless sill and the factory sill. Start to peel
the liner from the chrome molding placing the molding directly to the factory sill
against the new stainless sill peeling the liner as your press firmly to set the trim
along the length. Cut away any excess trim with a razor blade being careful not
to cut the plastic sill.
4. You have been provided with a brushed stainless inner sill plate. Gently and
accurately form this sill by hand so that it conforms to the top shape of the
factory sill. Once this sill has been properly shaped simply peel the release liner
and press firmly into position. Remove the protective liner and repeat steps 1-4
for the opposite side.
Note: Care must be taken when cleaning your doorsills. It is a good idea to lightly dust
your sills with a clean soft cloth first in order to prevent any particles from scratching
them. Then wipe (using a new clean soft cloth) with a good quality streak free glass
cleaner.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520