Assembly, Parent organizer assembly – BabyTrend PY86045 - DELUXE NURSERY CENTER - SKYLAR User Manual

Page 9

ASSEMBLY

4. Insert Connector Knob Prongs into holes

located on both corners of the Playard

(Fig. 38).

5. Turn the Connector Knobs counter clockwise

to lock into place (Fig. 39).

6. Flip Changing Table over onto Playard

(Fig. 40).

7. Snap the two (2) buttons on the flap down

onto the Playard (Fig. 41).

IMPORTANT:

Check that the Changing Table

is correctly and securely installed BEFORE

each use.

To use changing table

restraint system

1. Place child on changing table, make sure hand

and arms are clear of the restraint. Bring the

restraint around the child's waist and clip the male

and female ends of the buckle together. (Fig. 42)
2. Tighten strap until fits snug around child's

waist.

DO NOT OVER TIGHTEN

. (Fig. 43)

3. To remove, unsnap the buckle.

ATTENTION:

NEVER

use changing table if it is damaged or

broken.

Fig. 47

To remove changing table

Flip Changing Table to the outside of the Playard.

Unsnap fabric flap of Changing Table from

Playard. Twist Connector Knobs clockwise to

unlock. (Fig. 44) Remove Changing Table from

Playard (Fig. 45) and disconnect the Short Bars

from the Curved Bar by pressing on the snap

buttons and pulling apart. Remove Curved Bar

from Changing Table sleeve.

Fig. 38

Fig. 39

Fig. 44

Fig. 41

Fig. 45

Fig. 40

Fig. 42

Fig. 43

PARENT ORGANIZER ASSEMBLY

1. Parent Organizer: Position each hook so that

the hooked end is facing the rear side of the

organizer. Press the hook down firmly into the

slot until it snaps into place. (Fig. 46)

Diaper Stacker: Skip to step 2.

2. Connect the Parent Organizer/Diaper

Stacker to the Playard by sliding the two (2)

connecting clips over an open portion of the

top rail of the Playard. (Fig. 47)

NOTE: The Parent Organizer/Diaper Stacker

can only be installed on open sides of the

Playard where the connecting clips can easily

be attached without interfering with other

features.

Parent Organizer

Diaper Stacker

Fig. 46