BabyTrend PY86045 - DELUXE NURSERY CENTER - SKYLAR - Manual (Page 8)

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
13 14
Contents:
(a) 1 Mobile Lower Arm
(b) 1 Mobile Arm Holder
(c) 1 Mobile Upper Curved Arm
(d) 1 Mobile Tri-shaped Arm
(e) 3 Toys (toys may vary)
1. Insert the Mobile Lower Arm (a) into the
Mobile Arm Holder (b) untill locked together
(Fig. 30).
2. Insert the Mobile Upper Curved Arm (c) into
the Mobile Lower Arm (a, b) until locked
together (Fig. 31).
3. Snap the Mobile Tri-shaped Arm (d) onto the
end of the Upper Curved Arm (a, b, c)
(Fig. 32). Connect each of the three Toys (e)
to the Mobile by threading the string into the
slot at the end of each arm.
4. Insert the bottom of the Mobile Arm into the
frame of the Playard (Fig. 33).
ASSEMBLY ASSEMBLY
(a)
(b)
(c)
Fig. 34
Fig. 35
Fig. 36
WARNING
FALL HAZARD:
To
prevent death or serious injury,
always keep child within arm's
reach.
Always use restraint belt to prevent
falls, see page 15 for details.
Contents:
(a) 2 Long Curved Bars
(b) 2 Short Bar with Connector Knobs
(c) 1 Changing Table
ATTENTION:
Playard must be fully assembled and securely
locked before installing or using the changing
table feature. (See To Assemble Playard section)
1. Connect the two (2) Long Curved Bars
together (Fig. 34).
2. Insert the assembled curved bars into the
Changing Table fabric (Fig. 35) Slide the
Curved Bars around inside sleeve of the
Changing Table.
3. Connect the two (2) Short Bars to each end
of the Long Curved Bar (Fig. 36) Make sure
that the knobs are both facing down and the
same direction on each end. (Fig. 37)
Fig. 37
(a)
(b)
(c)
(d)
(e)
(a)
(b)
Fig. 30
(c)
(a)
(b)
Fig. 31
Fig. 32
Fig. 33
(d)
(e)
Fixed Mobile TO ASSEMBLE CHANGING TABLE