Assembly – BabyTrend PY86045 - DELUXE NURSERY CENTER - SKYLAR User Manual

Page 4

ASSEMBLY

ATTENTION: Some playard maybe fully

assemble. If so, skip to step 5.

3. Attach the Legs to the Playard by pushing each

Leg into the bottom of the leg mount until both

sides snap firmly into place (Fig. 3).

IMPORTANT: Check that each Leg is

securely attached before use.

4. Attach the Wheels to the Playard using the

axles, retainers and caps provided. Align each

Wheel and insert axle through the center

(Fig. 4). Secure by pushing the retainer over

the end of the axle until it snaps into place

(Fig.5). Finish by pushing the cap over the

end of the axle and retainer until it snaps into

place (Fig. 5).

IMPORTANT: Check that each Wheel is

securely attached before use.

NOTE: To operate the brakes on the Wheels,

press downward on the brake levers. To

release, lift upward on the lever (Fig. 6)

5. Turn the Playard right side up and keep the

Legs and Wheels close together. Stretch out

top of Playard and pull up one side at a time of

each of the top rails until each latch “Clicks”

and locks securely into place (Fig. 7).

NOTE: The best way to lock the rail(s) is to

hold one hand on each side and pull up sharply.

(DO NOT pull from the middle where the latch

release is located).

IMPORTANT: The handle located in the

center of the Playard floor MUST remain raised

(Approx. 45.7 cm or 18 inches) while locking

the side rails in place. If the center is not raised

the rails will NOT lock.

If you experience difficulty and one side of the

rail will lock but the other side will not then,

unlock the rail by squeezing the release in the

center and try again. If you still have difficulty,

contact our Customer Service Center at

1-800-328-7363 or visit us online at

www.babytrend.com.

Fig. 8

Fig. 9

Fig. 10

Fig. 11

Fig. 12

6. Once all four (4) top rails are locked in place,

push down on the center handle (Fig. 8). The

center mechanism will rotate clockwise 90

degrees and automatically lock in place.

IMPORTANT:

Test each top rail by pushing

down slightly to confirm each is rigid and

locked securely in place before use

(Fig.9)

ATTENTION:

To use as a bassinet, skip to page 7 for bassinet

installation instructions.

7. Place the Mattress on the floor of the Playard

with the padded side facing up (Fig. 10)

8. Feed the three (3) hook and loop straps located

on the underside of the Mattress through the

slots in the floor of each end of the Playard

(Fig. 11). Fasten the hook and loop straps to

the underside of the Playard floor to prevent the

Mattress from moving (Fig. 12).

Fig. 4

Insert

axle from

outside

Outside

Inside

Fig. 5

Fig. 7

Fig. 6

Fig. 3

Right leg

Left leg