Rainbow Electronics MAX5173 - Manual (Page 5)

MAX5171/MAX5173
Low-Power, Serial, 14-Bit DACs
with Force/Sense Voltage Output
_______________________________________________________________________________________ 5
Note 1: INL guaranteed between codes 64 and 16383.
Note 2: Offset is measured at the code that comes closest to 10mV.
Note 3: Accuracy is better than 1.0 LSB for V OUT = 10mV to V DD - 180mV. Guaranteed by PSR test on end points.
Note 4: R L = open and digital inputs are either V DD or DGND.
Note 5: INL guaranteed between codes 128 and 16383.
ELECTRICAL CHARACTERISTICS—MAX5173 (continued)
(V DD = +2.7V to +3.6V, V REF = 1.25V, AGND = DGND, FB = OUT, R L = 5k
Ω
, C L = 100pF referenced to ground, T A = T MIN to T MAX ,
unless otherwise noted. Typical values are at T A = +25°C).
µA 1 10 Shutdown Current (Note 4)
ns 150 t CP SCLK Clock Period
ns 75 t CH SCLK Pulse Width High
ns 75
CONDITIONS
t CL SCLK Pulse Width Low
ns 60 t CSS
CS Fall to SCLK Rise Setup
Time
ns 0 t CSS
SCLK Rise to CS Rise Hold
Time
ns 60 t DS SDI Setup Time
ns 0 t DH SDI Hold Time
C LOAD = 200pF ns 200 t DO1
SCLK Rise to DOUT Valid
Propagation Delay
ns 75 t CS1
CS Rise to SCLK Rise Hold Time
C LOAD = 200pF ns 200 t DO2
SCLK Fall to DOUT Valid
Propagation Delay
To ±0.5LSB, from 10mV to full-scale µs 12 Output Settling Time
ns 10 t CS0 SCLK Rise to CS Fall Delay
ns 150 t CSW
CS Pulse Width High
V/µs 0.6 SR Voltage Output Slew Rate
V 0 V DD Output Voltage Swing (Note 3)
µA -0.1 0 0.1 Current into FB
µs 40 Time Required to Exit Shutdown
UNITS MIN TYP MAX SYMBOL PARAMETER
CS = V
DD , DIN = 50kHz; f SCLK = 100kHz,
V SCLK = 3Vp-p
nV-s 1 Digital Feedthrough
V 2.7 3.6 V DD Positive Supply Voltage
mA 0.26 0.35 I DD Power-Supply Current (Note 4)
DYNAMIC PERFORMANCE
POWER SUPPLIES
TIMING CHARACTERISTICS