Rainbow Electronics QIL-A9260-C11 - Manual (Page 9)


Four Universal Synchronous/Asynchronous Receiver Transmitters (USART)
✔
Individual Baud Rate Generator, IrDA® Infrared Modulation/Demodulation,
Manchester Encoding/Decoding
✔
Support for ISO7816 T0/T1 Smart Card, Hardware Handshaking, RS485 Support
✔
Full Modem Signal Control on USART0

Two 2-wire UARTs

Two Master/Slave Serial Peripheral Interfaces (SPI)
✔
8- to 16-bit Programmable Data Length, Four External Peripheral Chip Selects
✔
Synchronous Communications

Two Three-channel 16-bit Timer/Counters (TC)
✔
Three External Clock Inputs, Two Multi-purpose I/O Pins per Channel
✔
Double PWM Generation, Capture/Waveform Mode, Up/Down Capability
✔
High-Drive Capability on Ouputs TIOA0, TIOA1, TIOA2

One Two-wire Interface (TWI)
✔
Master, Multi-master and Slave Mode Operation
✔
General Call Supported in Slave Mode
✔
Connection to PDC Channel To Optimize Data Transfers in Master Mode Only

IEEE® 1149.1 JTAG Boundary Scan on All Digital Pins

Required Power Supplies:
✔
1.65V to 1.95V for VDDBU, VDDCORE, VDDOSC and VDDPLL
✔
3.0V to 3.6V for VDDIOP0, VDDIOP1 (Peripheral I/Os) and VDDANA (Analog to
Digital Converter)
✔
Programmable 1.65V to 1.95V or 3.0V to 3.6V for VDDIOM (Memory I/Os)

Available in a 208-lead PQFP and 217-ball LFBGA Package
Datasheet USG-00006-A01 9/20