TC Electronic Finalizer 96k - Manual (Page 51)

51
TROUBLESHOOTING
You press the POWER switch but there is no light.
- The Power switch on the rear panel is switched off.
The Input PPM meters don’t peak out.
- You are using Analog Inputs, but the Input selector in the I/O
menu is set to Digital in.
- The Analog Input level is set too low.
No sound through the Finalizer.
- You are using Analog Inputs, but the Input selector in the I/O
menu is set to Digital in.
You cannot turn the power off.
- Hold the POWER key pressed for at least 3 seconds.