TC Electronic Finalizer 96k - Manual (Page 35)

35
TOOLS Phase Meter (correlation)
Time/division
Curve speed
TOOLS Calibration Tone
Phase Meter
The Phase meter shows you the phase relationship
between the two channels.
Plus means that the two channels are in phase.
Minus means that the two channels are relatively out
of phase.
Time/division
Sets the curve drawing speed.
Calibration tone
In the Calibration display you have a 1000Hz
test-tone, which will be sent to the Finalizer’s
Outputs at the selected level.
Set the level by using the ADJUST wheel and
press OK to activate.