TC Electronic RH750 - Manual (Page 8)

6
QuIck Setup guIde
If you just can’t wait…
Here are a few quick steps to get you playing within minutes.
Unpacking
• Unpack your RH750 amp.
• The box should contain the following items:
– RH750 amplifier
– Power Cable
– RCA to Mini-jack cable
– Manual
• Inspect all items for signs of transit damage. In the unlikely
event of this having occurred, inform the carrier and supplier.
• Keep all the packaging if damage has occurred, as this will
show evidence of excessive handling force.
• It is also a good idea to keep the packaging for future
transportation.
Setting up
• Connect the Speaker Out jack of the amplifier to your
cabinet using a speaker cable. Both Speakon and ¼” jack
cables can be used.
• You can connect up to three TC Electronic RS cabinets
or any other two 8 Ohm cabinets of another brand to the
amplifier. (minimum load: 4 Ohm).
• Connect the power cable and power up. RH750’s power
supply accepts voltages from 100 to 240 VAC.
• Connect your bass to the input jack on the front panel.
• Adjust the input gain using the GAIN knob.
• Adjust the output volume using the MASTER knob.
• Play!
Accessories
The following items can be purchased at your music dealer:
• RS210, RS410, RS112 and RS212 cabinets.
• RC4: A pedal with four footswitches that can use to switch
between three memory locations and also to mute for tuning
purposes. This pedal also shows tuner information.
• 19” bracket that allows you to mount the amplifier in a
standard 19” rack.
• Soft bag with sufficient space for both the RH750 amplifier
and the RC4.
• Flight cases for the RH750 amplifier and the RC4.
• Flight cases for some RS cabinet models.
Be sure to check www.tcelectronic.com for latest news about
these and other TC Electronic products.