RocketFish RF-G1182 - Quick Setup Guide User Manual
Page 2
1 Make sure that the HDMI splitter’s power adapter is plugged in.
One-year limited warranty
Visit www.rocketfishproducts.com for details.
Contact Rocketfish:
For customer service call 1-800-620-2790
www.rocketfishproducts.com
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richfield, MN 55423-3645 USA
© 2012
BBY Solutions, Inc., All Rights Reserved. ROCKETFISH is a
trademark of BBY Solutions, Inc.
All other products and brand names are trademarks of their
respective owners.
Troubleshooting
ENGLISH 11-1156
LED is not on or lit
Symptom
Possible solution
No video
and/or audio
Video has
some noise
When one device
destination is
turned off, the
other loses signal.
Specifications
1 When connecting one source device to a display and AVR,
make sure the display is connected to OUT 1 and the AVR is
connected to OUT 2.
2 When connecting one source device to two displays, make
sure that the destination component with the lowest
resolution is connected to the OUT 1 port to make sure video
is displayed. The splitter uses the resolution, timing
information, and audio formats of the destination
component with the lowest resolution for both destination
components.
3 Make sure that the audio and video formats of the content
being used (such as Blu-ray disc) are supported by all
connected devices.
4 Make sure that your destination components (such as TV and
A/V) receiver are set to the HDMI inputs with which the
splitter’s HDMI outputs are connected.
5 Make sure that you are using high-speed HDMI cables for
all connections.
6 Unplug the HDMI splitter’s AC power adapter, then plug it
back in again.
1 Make sure that you are using high-speed HDMI cables for all
connections.
2 Make sure that the TV’s video resolution supports the video
source’s output resolution.
3 Make sure that the destination component with the lowest
resolution is connected to the OUT 1 port to make sure video
is displayed. The splitter uses the resolution, timing
information, and audio formats of the destination
component with the lowest resolution for both components.
1 If you prefer the option of turning off individual devices
independent of one another, make sure the CEC function is
disabled on all the connected devices. See the user guide
supplied by the device manufacturer for more information
about CEC commands.
HDMI version
1.4A
Video amplifier bandwidth
225MHz / 6.75 Gbps
Resolutions supported
480i to 1080p from source device
Vertical frequency range
25Hz to 60Hz
HDMI input connector
HDMI Type A (1)
HDMI output connector
HDMI Type A (2)
HDMI HDCP compliant
Pass HDCP data between source and monitor
Power 5 VDC / 1000 mA (5 W max)
Dimensions
5.19 Ч 3.39 Ч 0.98 in. (130 Ч 86 Ч 25 mm)
Shipping weight
.82 lb. (.372 kg)