RocketFish RF-WHTIB - Quick Setup Guide - Manual (Page 2)

To connect the wireless receiver to a power outlet:
Note: Plug the power cord in only after all speakers are connected to the wireless receiver.
1 Plug the small (female) end of the power cord into the AC 100-240V~
50/60Hz jack on the back of the wireless receiver.
2 Plug the large (male) end of the power cord into a power outlet.
V1 ENGLISH 13-0051
Connecting the wireless receiver to your rear speakers
1 Connect the right speaker to the right speaker terminals of the wireless
receiver, and the left speaker to the left speaker terminals.
2 If the speakers have wires instead of terminals, connect the positive (+)
wire from the right speaker to the red (+) terminal for the right speaker on
the wireless receiver and the negative (-) wire from the right speaker to the
black (-) terminal for the right speaker on the wireless receiver.
3 Connect the left speaker the same way.
Connecting the wireless sender and wireless receiver
to a power outlet
To connect the wireless sender to the power adapter:
The power adapter can be connected to a power outlet or the SWITCHED AC
outlet of your home theater receiver. If you connect it to the SWITCHED AC
outlet of your home theater receiver, each time you turn your home theater
receiver on or off, the wireless sender is also turned on or off.
Using your universal wireless rear speaker kit
Establishing communications between the wireless sender and
wireless receiver
To turn on the system:
1 Turn on the power switch on the back panel
of the wireless sender. The LED indicator
blinks to indicate that the wireless sender is
plugged in.
2 Turn on the power switch on the back panel
of the wireless receiver. The LED indicator
blinks to indicate that the wireless receiver
is plugged in.
The wireless sender and wireless receiver
were pre-paired at the factory. When an
active link is established between them, the
LED indicators turn solid.
Note: In case the indicators continue to blink after 30
seconds, it means there is no active link between the
wireless sender and wireless receiver. Try to connect the
system manually using the CONNECT button. For more
information, see your User Guide.
Listening to the system
1 Turn on the system. Make sure that there is an active link between the
wireless sender and wireless receiver.
2 Turn on your home theater receiver, then play the audio or video
source through your home theater receiver.
The volume control on the wireless receiver is only used to adjust the
balance of the volume between the front and rear speakers. After the
system is set up, we recommend that you adjust the volume balance
one time.
One-year limited warranty
Visit www.rocketfishproducts.com for details.
Contact Rocketfish:
For customer service please call 1-800-620-2790
www.rocketfishproducts.com
ROCKETFISH is a registered trademark of BBY Solutions, Inc. Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2013 BBY Solutions, Inc. All Rights Reserved.
Left rear
speaker Right rear
speaker
Wireless sender back panel
Connecting the
power adapter
Wireless receiver back panel
Connecting the power cord
100-240V~ 50/60Hz
Plug the power cord in only after all
speakers are connected to the receiver.
Blinking LED
Blinking LED
Caution: To avoid risk of fire,
and to prevent damage, only
use the power adapter
supplied with your wireless
rear speaker kit.