Moog Music MF-104M Analog Delay - Manual (Page 4)

6 7
LFO CONTROLS (RIGHT PANEL):
LFO - Six-position rotary switch selects the LFO wave shape for delay
time modulation. Select from Sine, Triangle, Square, Ramp, Sawtooth, and
Sample and Hold modulation.
LFO RATE - Adjusts the LFO rate from 0.05 Hz to 50 Hz (wider range
available via control voltages and MIDI).
LFO AMOUNT - Controls the amount of LFO modulation of the delay time.
NOTE: More details on these controls can be found on page 17.
THE MF-104M BACK PANEL
The BACK PANEL has all the connection points for sending audio signals in
and out, control voltage inputs, MIDI input, and power supply connector.
THE MF-104M FRONT PANEL
The FRONT PANEL of the MF-104M Analog Delay contains the
performance controls and LED indicators.
MF-104M
ANALOG DELAY
TAP TEMPO
TIME
SHORT LONG
.2
.1 .6
.3
DELAY LINE CONTROLS (LEFT PANEL):
TIME - Adjusts delay times from 40ms to 400ms in Short mode and 80ms
to 800ms in Long mode.
RANGE - Selects between Short and Long delay times and bright or dark
filter. The Short setting is brighter while the Long setting is darker.
FEEDBACK - Provides continuous control from no feedback to greater
than infinite.
NOTE: Feedback settings above 8 can cause the unit to self-oscillate.
LEVEL CONTROLS (CENTER PANEL):
DRIVE - Allows 35 dB of adjustment of the input signal for optimum signal
path, level matching and overdriving sound sources.
OUTPUT - Allows gain and attenuation of output signal for compatibility
with a wide range of input devices.
MIX - Crossfader control for blending wet and dry signals to the output.
AUDIO IN FEEDBACK TIME LFO RATE MIX
MIX OUT DELAY OUT FB INSERT LFO AMT MIDI IN
+9V
400 mA
AUDIO IN - 1/4” TS jack. Accepts any instrument level to line level
audio signal.
MIX OUT - 1/4” TS jack. Adjustable output level for instrument or line
level output.
DELAY OUT - 1/4” TS jack. Supplies wet-only output.
FEEDBACK, TIME, LFO RATE, MIX, LFO AMOUNT - All are 1/4” TRS
jacks that accept Moogerfooger EP-2 (or equivalent) expression pedals,
or 0-5VDC control voltages from either two-circuit (TS) or three-circuit
(TRS) 1/4” jacks.
FEEDBACK INSERT - Supplies line-level send and return via a 1/4” TRS jack
for inserting effects into the feedback loop of the Delay line
MIDI IN - Accepts a 5-pin DIN input for controlling the MF-104M via MIDI.
+9VDC POWER JACK - Accepts standard 9 volt center positive barrel
power adaptor (power adaptor included). 400mA minimum required.
NOTE: More details on these connections can be found on page 20.