Moog Music Minimoog Voyager XL - Manual (Page 36)

Page 38
Voyager XL User’s Manual - The Components
Page 39
Voyager XL User’s Manual - The Components
LFO
This group of outputs is generated from the Voyager’s Primary LFO. There are two CV waveforms available
here (triangle and square) and both can be used at the same time
TRIANGLE: This is the triangle wave output of the LFO.
SQUARE: This is the square wave output of the LFO.
BUSSES:
This group of outputs is generated by the Mod Buss signals. They are the Modulation source after being
shaped by the SHAPING signal at the level determined by the AMOUNT control and the MOD WHEEL or
signal at the MOD1 Input jack
WHEEL: This is the output of the Mod Wheel Mod Buss. It is the Mod Wheel SOURCE shaped by the
SHAPING signal. The level is determined by the AMOUNT control and the MOD WHEEL.
PEDAL: This is the output of the Pedal/On Mod Buss. It is the Pedal/On SOURCE shaped by the
SHAPING signal. The level is determined by the AMOUNT control and the signal at the
MOD1 Input jack.
ENVS
This group of outputs is the output of the Envelope Generators.
FILTER: This is the CV output of the Filter Envelope Generator.
VOLUME: This is the CV output of the Volume Envelope Generator.
S & H
This group of outputs is generated by the Sample and Hold Circuit.
STEP: This is the output of the Sample and Hold Circuit.
SMOOTH: This is the Smoothed output of the Sample and Hold Circuit.
MULT
The Patch Panel features three 4-way Mults (Multiples). A mult is used to distribute a single source (output)
to multiple destinations. An example is connecting the Voyager XL Primary LFO to the Volume, Filter and
Pan Control Inputs. In this case, all three of those parameters will be controlled simultaneously by the LFO.