Grain Systems Unload Augers PNEG-1057 - Manual (Page 22)

10" Vertical Assembly
14
8" & 10" Commercial Vertical Bin Unloading Auger - PNEG 1057
G. Clamp belt guard mounting angle (30) to rod ends (25) with clamp bar (31) using four 5/16" x 1-3/4" bolts
with nuts.
H. Attach belt guard back (28) to belt guard mounting angles (21) using four 5/16" x 3/4" carriage bolts with flat
washers and nuts.
I. Slide bearing lock collar (40) over head stub shaft (39). Leave enough stub exposed to mount pulley (21) on stub
with drive key (41). Tighten bearing lock collar next to bearing and tighten set screws in pulley.
J. Position motor mount straps (15) and clips (14) and secure using four 3/8" x 3" carriage bolts and nuts. Leave
finger tight until later.
K. Install pulley on motor shaft and mount motor on strap (15). (Motor and pulley not furnished.) Install belts (3)
and align pulleys. Tighten motor to straps (15). Adjust motors along the tube and tighten with 3/8" x 3"
carriage bolts.
L. Set belt tension by adjusting height of motor using 3/4" nuts on rods.
L. Connect belt guard (29) by bolting belt guard clamp bar (33) to mounting angle (21) using 1/4" x 5-1/2" bolts
with nuts. Attach second clamp bar (32) to belt guard mounting brackets (30) using 1/4" x 5-1/2" bolts.
24
6
39
5
47
22
21
16
29
33
32
6
14
6
25 26
15
8
21
30
25
31
15
28
27
3
40
41