Grain Systems Tanks PNEG-256 - Manual (Page 56)

56 PNEG-256 6', 7' & 9' Bulk Feed Tanks
11. RAISING BIN
Raising Bin to set on Foundation
Preparing Bin
Just before standing the bin upright, peel protective mask off the decal while it is easy to reach.
Mask may become difficult to remove if left exposed to sunlight.
Check for all possible overhead obstructions, power line, etc., BEFORE standing the bin
on the foundation.
To prevent damage to Legs when raising bin, brace them with 2" x 4 " (50 mm x 100 mm) pieces
of wood as shown in the illustration. See the chart for the correct length.
Do not raise tank near power lines. Electrocution could occur if the tank came into contact
with live power lines.
Figure 11A
Be sure that all bolts are tightened properly. Bulk feed tank can now be set up on foundation.
Small bulk feed tanks may be set up with manpower. As the tanks get taller and heavier, other
means must be used to raise the bulk feed tank. A small crane of adequate capacity attached to
a cable or sling secured around the bulk feed tank just above the legs will usually do the job.
Refer any questions to a qualified rigger.
Bin Size 2 x 4 Length
6' Dia. (1,829 mm) 51.3/8" (1,305 mm)
7' Dia. (2,134 mm) 59.7/8" (1,521 mm)
9' Dia. (2,743 mm) 52.1/8" (1,324 mm)
WARNING
2'' x 4''
Anchor or stabilize to prevent sliding
during raising
Location of Cable or Sling wrapped
around tank
Bottom
End View