Grain Systems PNEG-951 - Manual (Page 39)

39 PNEG-951
1. Press the button. Press (enter twice) to bypass the other screens.
2. Press the button.
3. Press the button to adjust the settings.
4. Press the button to accept the changes.
Unload Delay
The unload delay is used to control the amount of time the unload auger runs after the metering rolls stop to
allow the unload auger to clean itself out.
To change the setting of this delay follow these instructions:
1. Press the button. Press (enter three times) to bypass
the other screens.
2. Press the button.
3. Press the button to adjust the settings.
4. Press the button to accept the changes.