Grain Systems Unload Augers PNEG-1521 - Manual (Page 34)

INSTALLATION
34 PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
D. Attach the Sweep Wheel Hub to the Gear Driven
Reduction Drive with one (1) 1/2” x 3-1/2” Grade 8
bolt and Stover nut.
E. Bolt the Segmented Rubber Wheel to the Sweep
Wheel Hub with four (4) ½” Nylock nuts.
F. Make final adjustments to the Back Shields and
mounting brackets, and tighten all hardware.
Remember to leave the Pivot bolt at the Gearbox
loose enough to pivot.
A single section of Sweep Flight and Back Shield, or just a few sections, can
be used alone without all the other sections. Install the Sweep Wheel at the
end of the last section being used.
FIG.12-D
12. SWEEP WHEEL INSTALLATION
(Cont.)
FIG.12-E
Sweep Wheel Hub
1/2" x 3-1/2"
Grade 8 Hex Bolt
1/2" Stover Nut
1/2" Nylock Nut
Segmented Rubber Wheel