Grain Systems Unload Augers PNEG-1521 - Manual (Page 26)

INSTALLATION
26
PNEG-1521 Commercial Direct Gear Drive Bin Sweep Auger
10. ASSEMBLING AND INSTALLING THE UNLOAD FLIGHT
(Cont.)
E. Insert the Unload Flight into the Unload Tube with
the Square bushing end facing the Centerwell,
and the Round bushing end facing the Discharge
End of the Tube.
Centerwell Square Shaft
Unload
Flight
FIG. 10-C
FIG. 10-B
F. When the Unload Flight is approaching the
Centerwell Square Shaft, it will be necessary to
rotate the Flight counter-clockwise to get it to seat
properly on the Square Shaft. When the Flight is
properly seated, the Flight should be entirely
inside the Unload Tube. It may be necessary to
pull the Flight out a small amount and attempt this
step multiple times in order to seat the Flight
properly.
G. On an initial install with an empty bin, the installer
should open the Centerwell Gate and enter the bin
to check and see that the Flight is seated. Once
they have seen that it has seated, they will know
the proper position the Flight is in on the
Discharge End, when seated properly.