beautypg.com

Installing the motor mount plate – Grain Systems Unload Augers PNEG-1556 User Manual

Page 16

background image

3. Installation

16

PNEG-1556 8", 10" and 12" Commercial Vertical Drive Unit - Dual Drive

Installing the Motor Mount Plate

A. Thread one of the motor mount adjustment nuts and one of the motor mount adjustment washers

approximately three-quarters (3/4) of the way down the motor mount adjuster’s threaded rod.

B. Once the nut and washer are in place, slip the motor mount plate over the adjuster and align the pivot

holes with the pivot tube.

(See Figure 3H below

and

Figure 3I on Page 17.)

Figure 3H

See also other documents in the category Grain Systems Equipment: