Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Programmer- AutoMind Programmer '03-05 Class-A MH - Manual (Page 6)

6
96374 v.4.0
9.
The Banks OttoMind programmer
will begin the stock tune back-up
process by copying the stock factory
tune currently installed in your vehicle.
10.
Note: During the back-up process,
the Banks OttoMind will build the Banks
Tune. After The Banks Tune is built,
press the ENTER key on the keyboard.
11.
Wait for 10 seconds. After waiting
for 10 seconds turn the ignition switch
to the OFF position, then press any
key to continue.
Note: Some vehicles may require the
key to be turned “OFF” then back
“ON” after the 10-second countdown,
if the “communicating” message is
displayed for more than 30 seconds.
12.
The Banks OttoMind programmer
will count 15 seconds until it is ok to
proceed. Turn the ignition On, then
press any key to continue. DO NOT
start the engine.
13.
Vehicle data backup is now
complete. Press any key to continue
installing the performance tune.
Install Performance Tune
14.
Select “ Install Tune” and press
the “Enter” button. See Figure 8)
15.
Select Banks Performance tune
by highlighting then press ENTER. See
Figure 9
16.
You will be asked if you wish to
continue the installation of the Banks
OttoMind tune. If you wish to continue
the Banks OttoMind tune press the
Enter button.
If you chose not to install the Banks
OttoMind tune then press ‘Esc’ for NO.
Note: The installation takes several
minutes to install.
17.
The Banks OttoMind message
center will display the percentage
of completion. When the process is
complete the message center will
display “uploading 100% completed”.
Press any key to continue the Banks
OttoMind tune installation.
18.
Turn the ignition off and then
press any key to continue.
19.
After waiting 10 seconds Turn
On the ignition switch and the press
any key to continue. Do not start the
engine.
Figure 8
Performance
Install Tune
Restore Factory Tune
Troubleshooting
Figure 9
Select Tune
Banks Performance
Figure 7
IPC Fuse Warning
Turn ignition on
(engine off).
Verify dashboard
lights do NOT come on
(Fuse 21 is pulled).