Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Tuner- Six-Gun Diesel Tuner '07-09 (PDA) Compatible w_ Optional PowerPDA - Manual (Page 12)

12
96508 v.7.0
7.
For the cleanest PowerPDA
installation (Figure 7), remove the
fuse access panel by pulling it out
from the side of the dash. Route the
RJ12 connector (phone like connector)
on the Banks OBD II Interface cable
under the dash and out where the
fuse access panel was. The RJ12
connectors’s cable can be slid under
the door frame’s seal and run up to
the top of the dash. Plug the RJ12
connector into one of the receptacles
in the base of the PDA docking station.
Re-install the fuse access panel.
8.
Plug the docking station’s charging
cable (seen in Figure 6) into the
charging receptacle on the lower edge
of the PowerPDA.
WARNING: The charging cable on
the docking station is designed
to supply a constant low-voltage
power source (+5vdc) to the
Banks PowerPDA and is “live”
as long as the system’s OBD II
Interface Cable is completely
installed and the RJ12 connector
is plugged into the docking
station. Although this charging
cable is short and it’s circuitry
Figure 8
Figure 7