Banks Power Universal Car & Truck: (Gas or Diesel ’50 - 14 Universal) Water-Methanol: Straight-Shot and Double Shot, Vehicle specific applications - Manual (Page 7)

97651 v.1.0
7
3.
Use provided bolts (P/N 91761), nuts
(P/N 91771), and washers (P/N 91102) to
mount pump in your truck. Tighten until
nylon locking feature is fully engaged and
rubber grommet is compressed at least
1/8.” Do not over tighten or damage to
grommets will occur. See Figure 9
Solenoid
: A solenoid (P/N 45035)
is only provided in the Double-Shot
system. Proceed to the Injection
Nozzle(s) section if you purchased
the Straight-Shot system.
: Solenoid must be
mounted upright and is flow direc-
tional with the ports labeled “IN”
and “OUT”. Take care while deter-
mining the mounting position in
your vehicle. See Figures 10 and 11.
1.
Determine where the solenoid will
be mounted so that it will not inter-
fere with moving or hot engine com-
ponents and will avoid spray and
debris from tires. Use solenoid brack-
et (P/N 45038) as a template to mark
where the bracket will be mounted. Ensure
that the desired location will not interfere
with vehicle operation and that drilling at
this location for mounting will be safe.
See Figure 12
: Take care while
drilling and know what is behind
the piece you are drilling through.
Note the location of the fuel tank,
fuel lines, wiring, etc.
2.
Use a center punch to mark the hole
location and keep the drill bit from wan-
dering. Use a 1/4” drill bit to drill nec-
essary holes where marked to mount
solenoid bracket. Deburr sharp edges.
See Figure 13
: Use eye and ear
protection while drilling.
Figure 10
Figure 12
Figure 11
Figure 13