Banks Power Ford Trucks: (Gas ’99 - 11 6.8L V10; 6.2L V8) AutoMind Flash Programmer for use with Banks iQ Flash - Manual (Page 15)

97276 v.1.0
15
Section 5
reSTorInG FACTory CALIBrATIon
IMPorTAnT! return the vehicle
back to Stock Calibration when
the vehicle will be serviced at
your dealer.
The stock calibration can be reinstalled
at any time by following the instructions
below. This feature will remove the
Banks AutoMind Flash calibration
and will return the vehicle to its stock
condition. The Banks AutoMind Flash
calibration will be saved in the Banks
AutoMind Programming Module.
1.
Plug the AutoMind Flash module
into the AutoMind Flash connector.
See Figure 2. Turn the key to the on
position to turn on your iQ and make
your way to the ‘Mode Select’ menu.
Scroll to the left or the right of menu
to locate the ‘AutMind Flash Program’
button and press to open the program.
2.
Press ‘PROGRAM VEHIcLE’ in the
main menu.
3.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine.
4.
Select ‘QUIcK TUNE’ in the ‘Vehicle
Tuning’ menu.
5.
Scroll up or down to highlight
the ‘Stock’ calibration and press the
‘INSTALL’ button. See Figure 10.
6.
Press the ‘YES’ button to continue
restoring stock calibration or ‘NO’
button to abort and go to the previous
menu.
WArnInG: Unplugging the
Banks AutoMind Programmer
while uploading or
downloading a calibration can
damage the vehicles eCM.
7.
The data transfer may take a few
minutes to complete. Once the upload
is complete you will be instructed to
“Turn Ignition Switch OFF and Remove
Key, Press OK to continue.” See
Figure 7.
8.
The original factory stock
calibration restoration is complete.
Press ‘OK’ to continue. Press the ‘iQ’
icon to return to the ‘Mode Select’
menu. You may unplug the Banks
AutoMind Flash Programmer Module
and drive your vehicle.
-END, SECTION 5-
Figure 10