Banks Power GM Motorhomes: (Gas ’82 - 95 7.4L) PowerPack system (Carbureted, dual air pump) - Manual (Page 5)

disconnect the plastic factory air inlet duct
at the air inlet hood. Remove the air inlet
hood from the mounting bracket by twisting it
until the four tabs line up with the slots in the
bracket. See Figure 3 .
Insert the Banks plastic bulkhead fitting
through the bracket from the back side.
The bulkhead fitting may be used as is, or the
curved portion may be cut off if this lines up bet-
ter with the factory air inlet duct. Figure 4 shows
where to cut the bulkhead if the curved portion is
to be removed.
drill four 3 ⁄
16
” diameter holes through the air
inlet hood bracket around the perimeter of
the center hole. See Figure 5 . if the bracket can-
not be drilled while in place, it may be unbolted
for drilling.
slip the bulkhead fitting into the end of the
factory air intake duct, and rotate the bulk-
head fitting into the desired mounting position.
Have someone hold the bulkhead fitting against
the mounting bracket from the back side while
you mark the centers of the four drilled hole loca-
tions. drill four 1 ⁄
16
” diameter holes into the bulk-
head fitting at these points.
5 P.n. 96341
6.
4.
5.
7.
banks raM-air
suPer-scooP
fIguRe 3
fiGure 4 fiGure 5