beautypg.com

7 motion detection, 8 privacy – Velleman CAMCOLD23 User Manual

Page 9

background image

CAMCOLD23 - CAMCOLD23W

V. 02 – 30/05/2013

9

©Velleman nv

7.7

Motion detection

Use this function to see motion detection during live monitoring. You
can use:

 Block display: in a grid of squares, select the areas where you

want to use motion detection. If the camera detects motion in one
of the enabled squares, the image in that square will ‘flash’.

 Monitor area selection: you can select up to 4 separate areas for

motion detection. If the camera detects motion, the outer edge of
the area will ‘flash’.

Display: MOTION DET
OFF Motion detection is switched off
ON Motion detection is active. Use the settings below.

DETECT SENSE: Set the motion detection sensitivity. With a
higher sensitivity, slighter movements will be detected.
BLOCK DISP: block display. Use this option to select squares

in a grid for motion detection.
1. Set BLOCK DISP to ENABLE and press the middle button.

The grid appears on the screen. Use the navigation buttons
on the joystick to select the squares and click the middle
button to enable/disable each of them for motion detection.

Motion is detected in the squares that show the grid.
Motion is not detected in squares that show the camera
image without grid. When you have finished, press and

hold the middle button for 3 seconds, then release.

2. Next, set BLOCK DISP to ON.

3. To disable block display, set BLOCK DISP to OFF.

MONITOR AREA: use this option to select a predefined
rectangular area for motion detection. You can define up to
4 areas.

1. First, set MONITOR AREA to ON.
2. Select which of the 4 areas you want to define in AREA

SEL (1/4 … 4/4).

3. Use the TOP, BOTTOM, LEFT, and RIGHT settings to

define the top, bottom, left, and right edge of the area.

7.8

Privacy

Use this function to block a part of the image where you don’t want
to view activity. For example, if part of the image shows a public
area where recording may be illegal. You can define up to 8 areas.