Velleman CAMCOLD23 - Manual (Page 5)

CAMCOLD23 - CAMCOLD23W
V. 02 – 30/05/2013 5 ©Velleman nv
4. Guide the power and video cable [9] through one of the cable
slots [8] and fix the mounting plate [1] on the ceiling or wall
with four screws.
5. Insert the lens enclosure [4] in the positioning ring [3] and slide
the fixation ring [2] over both. Point the camera towards the
desired field of observation and screw the fixation ring [2] back
on the mounting plate [1].
6. Connect the video connector [A] to a monitor (not incl.) or a
sequential switcher/quad splitter (not incl.) when connecting
multiple domes.
7. Connect the power connector [B] to a 12VDC power supply (not
incl.)
7. OSD Settings
There is a small joystick in the camera cable that allows you to
adjust the settings of the camera using an on-screen display (OSD).
 Press the middle button to access the menu, or
to select an option.
 Press the up and down buttons to move up and
down in the menu.
 Press the left and right buttons to modify the
menu parameters.
In the OSD menu:
 NEXT/BACK: select this option and press the middle button to go
to the next/previous page of options in the menu.
 RETURN: select this option and press the middle button to return
to the previous level in the menu.
 EXIT: select this option and press the middle button to leave the
OSD menu without saving the settings.
 SAVE ALL: select this option and press the middle button to save
all settings.
 CAMERA RESET: select this option and press the middle button
to reset the camera to the factory defaults.
The OSD menu settings are described in detail below.
7.1
Lens
The LENS menu is not applicable to this camera. You can leave the
settings as they are.