Velleman HAA85BL User Manual

Page 10

HAA85BL

15/11/2013

VELLEMAN

9270 stored as user code 3 for output 3

Output 1 set as momentary mode, 1 second

Output 2 set to start / stop mode

Output 3 set to start / stop mode

Keypad set to lock during 15 minutes after 10 successive false
codes

Exit programming mode. All above data stored and ready for use

NOTE: * Entering single user command code 8900 is not necessary if the keypad was already in single

user mode.
Cancel a wrong entry with

or wait 10 seconds and retry.

Operating the keypad – Taking the data programmed above and other default features as reference

To command an output, only enter the user code. Pressing

is not required.

Output 1 activates for 1 second

Output 2 starts or stops

Output 3 starts or stops

The personal master code is a super user code to command the outputs. This feature allows you to use
only one code to operate several keypads with the same master code but different user codes. Enter
the personal master code and validate with

and the corresponding output number.

Output 1 activates for 1 second

Output 2 starts or stops

Output 3 starts or stops

The duress code does not need to be programmed. The keypad automatically determines the duress
code by increasing the first digit of user code 1 with two units.
Example: If user code 1 is 1234, then the duress code will be 3234. If user code 1 is 8321, then the

duress code will be 0321.

To command the duress function, enter the duress code.

Duress output activates (output switches to (-) ground) and
output 1 activates for 1 second

NOTE: The duress code has 2 functions: it activates the duress output and at the same time it activates

output 1 as user code 1. The duress code can always activate or deactivate (in start / stop mode)
output 1, but cannot deactivate (reset) the duress output.

The accelerated code is the first two digits of the user code. If output 1 has been programmed in start /
stop mode with accelerated code at location 42, it will be possible to activate output 1 with only the first
two digits of the user code. Deactivation always requires the composition of the complete user code.
Example: Output 1 has been reprogrammed to start / stop mode with accelerated code (location 42).

Complete code: 8321, accelerated code: 83.