Velleman CAMIP16 Quick Installation Guide - Manual (Page 29)

29
APPENDIX 1 PRODUCT SPECIFICATIONS
Model 1 Model 2
▓ Network
LAN Port YES
LAN Speed 10/100 Based-T Ethernet
Supported Protocols
DDNS, PPPoE, DHCP, NTP, SNTP, TCP/IP, ICMP, SMTP, FTP, HTTP, RTP, RTSP, RTCP,IPv4,
Bonjour, UPnP, DNS,UDP,IGMP, QoS
Number of Online Users 10
Security
(1) Multiple user access levels with password
(2) IP address filtering
(3) Digest authentication
Remote Access
(1) Internet Explorer on Windows operating system
(2) EagleEyes on iPhone, iPad & Android mobile devices
▓
Video
Video Compression H.264 / MPEG4 / MJPEG
Resolution 1080P, SXGA, 720P, VGA, QVGA SXGA, 720P, VGA, QVGA
Frame Rate 30fps
Multiple Video Streaming 3 (H.264, MJPEG, MPEG4)
▓
General
Image Sensor 1/2.9" CMOS image sensor 1/4" H.R. image sensor
Min Illumination 1 Lux / F1.4, 0 Lux (LED ON)
S/N Ratio More than 48dB (AGC off)
Electronic Shutter 1/2 to 1/10,000 sec
Lens f2.8 ~ 12mm / F1.4 ~ F2.8
Viewing Angle
Wide: 109° (Horizontal) / 76° (Vertical) /
116° (Diagonal)
Tele: 24° (Horizontal) / 13.5° (Vertical) /
27° (Diagonal)
Wide: 66° (Horizontal) / 52° (Vertical) /
90° ( Diagonal)
Tele: 16° (Horizontal) / 10° (Vertical) /
22° ( Diagonal)
IR LED 2 Units
IR Effective Range **
Default : up to 25 meters
IR Enhanced Mode : up to 35 meters
IR Shift YES
IRIS Mode AES
White Balance ATW
AGC Auto
Micro SD Card Slot YES
IP Rating IP66
Operating Temperature -20℃~40℃
Power Source (±10%) 12V / 1.5A
Current Consumption (±10%) 11W (IR On)
▓ Others
Mobile Surveillance iPad / iPhone / Android mobile device
ONVIF Compatible YES
POE (Power-over-Ethernet) YES (IEEE 802.3af)
Event Notification FTP / Email / SMS
External Alarm Device Connection YES
Digital Pan / Tilt / Zoom YES
Motion Detection YES
RTC (real-time clock) YES
Minimum Web Browsing Requirements
Intel core i3 or higher, or equivalent AMD ‧
2 ‧ GB RAM
AGP graphics card, Direct Draw, 32MB RAM ‧
Windows ‧ 7, Vista & XP, DirectX 9.0 or later
Internet Explorer ‧ 7.x or later
* The specifications are subject to change without notice. ** Dimensional tolerance: ± 5mm