VEGA VEGABAR 86 Modbus and Levelmaster protocol - Operating Instructions - Manual (Page 37)

37
6 Set up with the display and adjustment module
VEGABAR 86 • Modbus and Levelmaster protocol
46296-EN-131107
In this menu item you gain access to the protected area where
you can enter special parameters. In exceptional cases, individual
parameters can be modified in order to adapt the sensor to special
requirements.
Change the settings of the special parameters only after having con-
tacted our service staff.
In menu item "Scaling" you define the scaling variable and the scaling
unit for the level value on the display, e.g. volume in l.
In menu item "Scaling (2)" you define the scaling format on the display
and the scaling of the measured level value for 0 % and 100 %.
In this menu item, you read out the instrument name and the instru-
ment serial number:
In this menu item, the hardware and software version of the sensor is
displayed.
In this menu item, the date of factory calibration of the sensor as well
as the date of the last change of sensor parameters are displayed via
the display and adjustment module or via the PC.
In this menu item, the features of the sensor such as approval, pro-
cess fitting, seal, measuring range, electronics, housing and others
are displayed.
Additional adjustments -
Special parameters
Setup - Scaling (1)
Setup - Scaling (2)
Info - Instrument name
Info - Instrument version
Info - Factory calibration
date
Info - Sensor character-
istics