VEGA VEGABAR 81 HART and accumulator pack - Operating Instructions - Manual (Page 36)

36
6 Set up with the display and adjustment module
VEGABAR 81 • HART and accumulator pack
45026-EN-131107
Note:
Before saving the data in the sensor, a safety check is made if the
data match with the sensor. For this purpose the sensor type of the
source data as well as the target sensor are displayed. If the data do
not match, a failure message is outputted or the function is blocked.
The data are only saved after release.
In this menu item you gain access to the protected area where
you can enter special parameters. In exceptional cases, individual
parameters can be modified in order to adapt the sensor to special
requirements.
Change the settings of the special parameters only after having con-
tacted our service staff.
In menu item "Scaling" you define the scaling variable and the scaling
unit for the level value on the display, e.g. volume in l.
In menu item "Scaling (2)" you define the scaling format on the display
and the scaling of the measured level value for 0 % and 100 %.
In menu item"Current output, size" you determine which measured
value the current output refers to.
In menu item "Current output, adjustment" you can assign a respec-
tive measured value to the current output.
The sensor offers the HART modes "Analogue current output" and
"Fix current (4 mA)". In this menu item you determine the HART mode
and enter the address with Multidrop mode.
Additional adjustments -
Special parameters
Setup - Scaling (1)
Setup - Scaling (2)
Additional settings - Cur-
rent output 1 and 2 (size)
Additional settings -
Current output 1 and 2
(adjustment)
Additional adjustments -
HART mode