VEGA VEGAFLEX 86 Modbus and Levelmaster protocol Coax probe - Manual (Page 34)

34
6 Set up with the display and adjustment module
VEGAFLEX 86 • Modbus and Levelmaster protocol
42288-EN-130314
In menu item "Current output, adjustment" you can assign a respec-
tive measured value to the current output.
In the menu item "Current output Min./Max.", you determine the reac-
tion of the current output during operation.
The default setting is min. current 3.8 mA and max. current 20.5 mA.
Since the HART variables are very extensive, the indication was
divided into two menu items.
In the menu "HART variables 1" you can have the first HART value PV
(primary value) and the second HART value SV (secondary value) of
the sensor displayed.
The values cannot be changed in the display and adjustment module.
To change these values, you have to use the adjustment software
PACTware.
In the menu "HART variables 2" you can have the third HART value
TV (third value) and the fourth HART value QV (quarter value) of the
sensor displayed.
The values cannot be changed in the display and adjustment module.
To change these values, you have to use the adjustment software
PACTware.
Setup - Current output,
adjustment
Setup - Current output
Min./Max.
Setup - HART variables
(1)
Setup - HART variables
(2)