VEGA VEGAFLEX 86 Modbus and Levelmaster protocol Coax probe - Manual (Page 23)

23
6 Set up with the display and adjustment module
VEGAFLEX 86 • Modbus and Levelmaster protocol
42288-EN-130314
6 Set up with the display and adjustment
module
6.1 Adjustment volume
The display and adjustment module is only used for parameter adjust-
ment of the sensor, i.e. for adaptation to the measurement task.
The parameter adjustment of the Modbus interface is carried out via
a PC with PACTware. You can find the procedure in chapter "Set up
sensor and Modbus interface with PACTware".
6.2 Insert display and adjustment module
The display and adjustment module can be inserted into the sensor
and removed any time. Four positions displaced by 90° can be se-
lected. It is not necessary to interrupt the power supply.
Proceed as follows:
1. Unscrew the housing cover
2. Place the display and adjustment module in the requested posi-
tion onto the electronics and turn to the right until it snaps in
3. Screw housing cover with inspection window tightly back on
Removal is carried out in reverse order.
The display and adjustment module is powered by the sensor, an ad-
ditional connection is not necessary.
Fig. 15: Insertion of the display and adjustment module with single chamber
housing
Note:
If you intend to retrofit the instrument with a display and adjustment
module for continuous measured value indication, a higher cover with
an inspection glass is required.