VEGA VEGAFLEX 86 Modbus and Levelmaster protocol Coax probe - Manual (Page 25)

25
6 Set up with the display and adjustment module
VEGAFLEX 86 • Modbus and Levelmaster protocol
42288-EN-130314
•
Software version (SW-Ver)
•
Hardware version (HW-Ver)
With the [->] key you can move between three different indication
modes.
In the first view, the selected measured value and a respective bar-
graph presentation are displayed.
In the second view, the selected measured value as well as a second
selectable value, e.g. the temperature value are displayed.
In the third view, the selected measured value is displayed in large
letters.
6.4 Parameter adjustment - Quick setup
To quickly and easily adapt the sensor to the application, select
the menu item "Quick setup" in the start graphic on the display and
adjustment module.
You can find "Extended adjustment" in the next sub-chapter.
Measurement loop name
In the first menu item you can assign a suitable measurement loop
name. You can enter a name with max. 19 characters.
Product type
In the next menu item you can see which product type the instrument
is suitable for. If your instrument is only suitable for a certain medium,
this menu item is not visible.
Application
In this menu item, you can select the application. You can choose
between level measurement and interface measurement. You can
also choose between measurement in a vessel or in a bypass or
standpipe.
Medium - dielectric constant
In this menu item, you can define the medium type (product).
Max. adjustment
In this menu item, you can enter the max. adjustment for the level.
Measured value indica-
tion
Quick setup
General information
Level measurement