VEGA FIBERTRAC 31 4 … 20 mA_HART - four-wire With SIL qualification - Manual (Page 10)

10
3 Product description
FIBERTRAC 31 • 4 … 20 mA/HART - four-wire
43386-EN-131119
•
Relative humidity 20 … 85 %
3.5 Accessories and replacement parts
The display and adjustment module PLICSCOM is used for measured
value indication, adjustment and diagnosis. It can be inserted into the
sensor or the external display and adjustment unit and removed at
any time.
You can find further information in the operating instructions "Display
and adjustment module PLICSCOM" (Document-ID 27835).
The interface adapter VEGACONNECT enables the connection of
communication-capable instruments to the USB interface of a PC. For
parameter adjustment of these instruments, the adjustment software
PACTware with VEGA-DTM is required.
You can find further information in the operating instructions "Interface
adapter VEGACONNECT" (Document-ID 32628).
The VEGADIS 81 is an external display and adjustment unit for VEGA
plics ® sensors.
For sensors with double chamber housing the interface adapter "DIS-
ADAPT" is also required for VEGADIS 81.
You can find further information in the operating instructions "VE-
GADIS 81" (Document-ID 43814).
The VEGADIS 62 is suitable for measured value indication of sensors.
It is looped into the 4 … 20 mA/HART signal cable.
You can find further information in the operating instructions "VE-
GADIS 62" (Document-ID 36469).
The electronics module PT30E.XX is a replacement part for radiation-
based sensors FIBERTRAC 31.
The electronics module can only be exchanged by VEGA service
technician.
3.6 Corresponding source container
A radioactive isotope in a suitable source holder is the prerequisite for
a radiation-based measurement setup.
The handling of radioactive substances is regulated by law. The radia-
tion protection rules of the country in which the system is operated
apply first and foremost.
In Germany, for example, the current radiation protection ordinance
(StrlSchV) based on the Atomic Energy Law (AtG) applies.
The following points are important for measurement with radiation-
based methods:
A handling permit is required for operation of a system using gamma
rays. This permit is issued by the respective government office or the
PLICSCOM
VEGACONNECT
VEGADIS 81
External indicating unit
Electronics module
Handling permit