VEGA VEGAPULS SR 68 4 … 20 mA_HART two-wire - Manual (Page 32)

32
5 Connecting to power supply
VEGAPULS SR 68 • 4 … 20 mA/HART two-wire
38294-EN-130624
Fig. 27: Connection steps 5 and 6 - Single chamber housing
Fig. 28: Connection steps 5 and 6 - Double chamber housing
6. Insert the wire ends into the terminals according to the wiring plan
Information:
Solid cores as well as flexible cores with wire end sleeves are insert-
ed directly into the terminal openings. In case of flexible cores without
end sleeves, press the terminal from above with a small screwdriver;
the terminal opening is freed. When the screwdriver is released, the
terminal closes again.
You can find further information on the max. wire cross-section under
"Technical data/Electromechanical data"
7. Check the hold of the wires in the terminals by lightly pulling on
them
8. Connect the screen to the internal ground terminal, connect the
outer ground terminal to potential equalisation