VEGA Replacement housing for plics instruments - Manual (Page 7)

4 Mounting
4.1 General instructions
If the housing is defective, it can be replaced by the user.
In Ex applications, only a housing with appropriate Ex approval
must be used.
If there is no housing available on site, it can be ordered from
the responsible VEGA agency.
The housings are suitable for all VEGA plics sensors in
respective version and signal output. First of all check by
means of the following overview if you have the suitable
housing.
The order number is stated on the delivery note of the
replacement housing.
4.2 Mounting preparations
The single chamber housing PLICSGEH.2... is suitable for all
instruments listed in chapter "3.2 Principle of operation". It is
available with the following approvals:
l
PLICSGEH...X (X = without approvals)
l
PLICSGEH...1 (1 = approval XM, CM, acc. to VEGA
product list)
l
PLICSGEH...2 (2 = approval DA, DM acc. to VEGA
product list)
l
PLICSGEH...3 (3 = approval GX, CK acc. to VEGA product
list)
The double chamber housing PLICSGEH2K ... is suitable for
the instruments listed in chapter "3.2 Principle of operation",
except for VEGASON 64, 65, 66 as well as VEGASWING 60
and VEGAVIB 60. It is available with the following approvals:
l
PLICSGEH2K...X (X = without approvals)
l
PLICSGEH2K...1 (1 = approval XM, CX, CA,CM, CI, UX,
UF acc. to VEGA product list)
l
PLICSGEH2K...2 (2 = approval GX, CK acc. to VEGA
product list)
l
PLICSGEH2K...3 (3 = approval DX, DA, DM, DI acc. to
VEGA product list)
l
PLICSGEH2K...4 (4 = approval DX, DA, DK, UX acc. to
VEGA product list)
Assignment
Single chamber housing
Double chamber housing
Replacement housing for plics instruments 7
Mounting
31150
-EN
-050802