VEGA VEGAFLEX 66 (-110…+400°C) Profibus PA - Manual (Page 42)

In both cases, the serial number of VEGAFLEX 66 is required.
The serial numbers are stated on the type label of VEGAFLEX
66, on the inner wall of the housing or on the delivery note.
The oscillators are adapted to the respective sensor and differ
in their signal output or in their power supply. You can find a
suitable oscillator in the following overview.
Electronics module FX-E.60P suitable for VEGAFLEX 61, 62,
63, 65, 66 - Profibus PA:
l
FX-E. 60PX (X = without approvals)
l
FX-E. 60PA (A = approvals CA, DA according to product
list)
l
FX-E. 60PC (C = approvals XM, CX, CM, CK, GX
according to product list)
8.4 Instrument repair
If a repair is necessary, please proceed as follows:
You can download a return form (23 KB) from our Internet
homepage www.vega.com under: "Downloads - Forms and
certificates - Repair form".
By doing this you help us carry out the repair quickly and
without having to call back for needed information.
l
Print and fill out one form per instrument
l
Clean the instrument and pack it damage-proof
l
Attach the completed form and probably the safety data
sheet outside on the packaging
l
Please ask the agency serving you for the address of your
return shipment. You can find the respective agency on our
website www.vega.com under: "Company - VEGA world-
wide"
On instruments with exchangeable rod, the rod must be
unscrewed for transport to avoid damages.
Return the parts separately for repair.
To loosen to rod, you require a fork spanner with wrench size
8.
1 Loosen the rod on the flat surfaces with a fork spanner
(SW 8), provide counterforce with another fork spanner
(SW 8)
2 Twist off the loosened rod manually
Assignment
Profibus PA
Return of rod versions
42 VEGAFLEX 66 • Profibus PA
8 Maintenance and fault rectification
32764
-EN
-080716