4 how to proceed in case of repair – VEGA VEGACAP 27 - Relay (DPDT) User Manual
Page 21
21
7 Maintenance and fault rectification
VEGACAP 27 • - Relay (DPDT)
33758-EN-130916
6. Loosen the two screws with a Torx screwdriver.
7. Open the tensile ring on the old electronics module and pull out
the old electronics module.
8. Compare the new electronics module with the old one. The type
label of the electronics module must correspond to that of the old
electronics module.
9. Insert the new electronics module.
10. Screw in and tighten the two screws with a Torx screwdriver.
11. Lead the connection cable through the cable gland.
12. Insert the wire ends into the open terminals according to the wir-
ing plan and tighten them.
13. Check the hold of the wires in the terminals by lightly pulling on
them.
14. Tighten cable gland and check on tightness. The seal ring must
completely encircle the cable.
15. Carry out a fresh adjustment. See chapter "Set up, new adjust-
ment".
16. Screw the housing cover back on
The electronics exchange is now finished.
7.4 How to proceed in case of repair
You can find a repair form as well as detailed information on how to
pr and "Forms and certifi-
cates".
By doing this you help us carry out the repair quickly and without hav-
ing to call back for needed information.
If a repair is necessary, please proceed as follows:
•
Print and fill out one form per instrument
•
Clean the instrument and pack it damage-proof
•
Attach the completed form and, if need be, also a safety data
sheet outside on the packaging
•
Please contact for the return shipment the agency serving you. You
can find the agency on our home page