VEGA VEGAWELL S 51 - Manual (Page 17)

Information:
For this purpose, we recommend
VEGABOX 02. It contains terminals and a
fi
lter element for pressure compensation. A
suitable protective cover is available for
outdoor mounting.
Mounting example
Fig. 10: Mounting example: VEGAWELL S 51 in a pump shaft with
breather housing VEGABOX 02
3 .2
Mounting steps with straining clamp
2
3
1
Fig. 11: Straining clamp
1 Suspension cable
2 Suspension opening
3 Clamping jaws
Mount VEGAWELL S 51 with straining clamp as
follows:
1 Hang the straining clamp on a suitable wall
hook
2 Lower VEGAWELL S 51 to the requested
height
3 Slide the clamping jaws upward and push the
suspension cable between them
4 Hold the suspension cable, push the clamping
jaws downward and fix them with a light blow
Removal is carried out in reverse order.
3 .3
Mounting steps with screwed
connection
1
2
3
4
5
6
Fig. 12: Threaded fitting
1 Suspension cable
2 Seal screw
3 Cone bushing
4 Seal cone
5 Threaded fitting
6 Seal
Mount VEGAWELL S 51 with screwed connection
as follows:
1 Weld the welded socket into the vessel top
2 Lower VEGAWELL S 51 to the requested
height by means on the welded socket G1½ A
or 1½ NPT on the vessel side
3 Insert the suspension cable from below into the
open screwed connection
4 Slide the seal cone and the cone sleeve over
the suspension cable, fasten manually with the
seal screw
5 Screw the screwed connection into the socket,
fasten with SW 30 and then fasten seal screw
with SW 19
How to correct the height:
1 Loosen seal screw with SW 19
VEGAWELL S 51 17
Mounting
32946
-
01
-
101123