VEGA VEGAWELL 51 4 … 20 mA_HART - Manual (Page 6)

D uring the entire duration of use, the user is obliged to
determine the compliance of the required occupational safety
measures with the current valid rules and regulations and also
take note of new regulations.
2 .5 Safety approval markings and safety tips
T he safety approval markings and safety tips on the device
must be observed.
2 .6 CE conformity
T he protection goals of the EMC Directive 2004/108/EC (EMC)
and the Low Voltage Directive 2006/95/EC (LVD) are fulfilled.
C onformity has been judged according to the following
standards:
EMC: EN 61326-1: 2006
(
electrical instruments for control technology and laboratory
use - EMC requirements)
l
E mission: Class B
l
S
usceptibility: Industrial areas
LVD: EN 61010-1: 2001
(
safety regulations for electrical measurement, control and
laboratory instruments - part 1: Gerneral requirements)
2 .7 Fulfilling of NAMUR recommendations
I n respect to interference resistance and emitted interference,
the NAMUR recommendation NE 21 is met.
I
n respect to compatibility, the NAMUR recommendation NE 53
is met. This applies also to the corresponding indicating and
adjustment components. VEGA instruments are generally
upward and downward compatible.
l
S ensor software to DTM VEGAWELL 51 HART
l
DTM VEGAWELL 51 for adjustment software PACTware™
T
he parameter adjustment of the basic sensor functions is
independent of the software version. The range of available
functions depends on the respective software version of the
individual components.
T he software version of VEGAWELL 51 HART can be read out
via PACTware™.
6 VEGAWELL 51 • 4 … 20 mA/HART
F or your safety
32468
-EN
-080604