VEGA VEGASON 64 Foundation Fieldbus - Manual (Page 16)

11 Secure screw (3) with lacquer or similar to ensure permanent
tightness of the swivelling holder
12 Rotate the connection head in such a way that the cable entry
points downwards (moisture can drain off). Fasten the cylinder
with screws (5); torque max. 5 Nm
13 Insert the plug at the end of the transducer cable into the socket on
the remote electronics
1
2 3
Fig. 7: Plug connector between transducer and socket of electronics housing
1
Socket electronics housing
2 Plug connector
3 Connection piece, transducer tube
Version D is supplied in three parts:
l Transducer
l Transducer cable
l electronics for wall mounting
Assemble the version as follows:
1 Loosen the hexagon nut (3) on the transducer cable
2 Insert the transducer tube from below into the mounting opening
G
1A
3 Fasten (SW 46) the hexagon nut (3)
4 Remove the plug from below out of the connection head and plug
it into the socket of the transducer tube
Mounting - Version D
16 VEGASON 64 • Foundation Fieldbus
4 Mounting
28793
-EN
-081127