VEGA VEGASON 66 Emitting electronics - Manual (Page 9)

1 Switch off power supply
2 Remove the housing cover from the electronics compart-
ment, or from the connection compartment of the Alu
double chamber housing, as the case may be
3 Disconnect the connection cables according to the
operating instructions manual of the respective sensor
4 Loosen the two holding screws with a screwdriver (Torx
size T 10 or slot size 2)
2
1
Fig. 7: Loosen the screws
1
Electronics module
2 Screws (2 pcs.)
5 Pull the electronics out by holding the opening levers.
Proceed as follows:
1 Loosen the screws of the check angle and the locking ring
with a Phillips screwdriver size 1
Remove the housing
Emitting electronics - for VEGASON 64, 65, 66 9
Mounting
30205
-
EN
-070510