VEGA VEGABAR 64 4 … 20 mA_HART - Manual (Page 33)

T o select the adjustment unit (in the example switching over from bar
to mbar) you have to proceed as follows: 2)
1 P ush the [OK] button in the measured value display, the menu
overview is displayed.
▶ B asic adjustment
D isplay
D iagnostics
S ervice
I nfo
2 C onfirm the menu "Basic adjustment" with [OK], the menu item
"Unit" will be displayed.
U nit
U nit of measurement
bar ▼
T emperature unit
°C ▼
3 A ctivate the selection with [OK] and select "Units of measure-
ment
with [->].
4 A ctivate the selection with [OK] and select the requested unit with
[->] ( in the example mbar).
5 C onfirm with [OK] and move to position correction with [->].
T he adjustment unit is hence switched over from bar to mbar.
Information:
W
hen switching over to adjustment in a height unit (in the example
from bar to m), the density also has to be entered.
P roceed as follows:
1 P
ush the [OK] button in the measured value display, the menu
overview is displayed.
2 C onfirm the menu "Basic adjustment" with [OK], the menu item
"Units of measurement" will be displayed.
3 A ctivate the selection with [OK] and select the requested unit with
[->] ( in the example m).
4 C onfirm with [OK], the submenu "Density unit" appears.
U nit of measurement
D ensity unit
▶ kg/dm³
pcf
5 S elect the requested unit, e.g. kg/dm³ with [->] and confirm with
[OK] , the submenu "Density" appears.
2) S election options: mbar, bar, psi, Pa, kPa, MPa, inHg, mmHg, inH
2
O,
mmH
2
O.
VEGABAR 64 • 4 … 20 mA/HART 33
6 S et up with the indicating and adjustment module PLICSCOM
27525
-
EN
-081209