VEGA PACTware-DTM Collection 01_2014 - Manual (Page 13)

13
5 Operation
PACTware/DTM Collection 01/2014 • Installation, first steps
28243-EN-131203
Fig. 5: Project with VEGAPULS
Project creation, VEGAMET 624 with sensor
The following example shows a typical project containing a sensor
connected to a VEGAMET 624. Communication with VEGAMET
624 is carried out in this example via network and Ethernet. We
recommend using the "VEGA project assistant" as this considerably
facilitates project creation and helps avoid errors. All participating
components are found automatically and integrated into the project.
In case the planning is nevertheless carried out manually, e.g. when
creating an offline project, the following DTMs must be added to the
project tree:
1. In the device catalogue, first select the "VEGA Ethernet" DTM
from the category "Driver" and transfer it, e.g. by double clicking,
to the project window.
2. Select the VEGAMET 624 DTM from the category "Gateways"
and transfer it to the project window.
3. Select the requested sensor DTM from the category "Device" and
transfer it to the project window.
4. Select the "VEGA-Ethernet" DTM in the project tree and select via
the right mouse key the menu item "Additional functions - Change
DTM addresses". Enter in the field "New address" the IP address
or the Host name the VEGAMET should get later on in real opera-
tion.
5. Now open the VEGAMET DTM and sensor DTM by double click-
ing and carry out the desired settings, see chapter "Parameter
adjustment".
Connection, VEGAMET
624 via Ethernet