VEGA VEGAFLEX 55K - Manual (Page 21)

VEGAFLEX 55K 21
- +
ESC
OK
Tank 1
m (d)
12.345
Setup
▼
▼
1
5
3
4
2
Adjustment elements
The adjustment module MINICOM is menu-
orientated. The clear text indications on the
display lead through the menu. The functions
of the keys are described below.
"OK" key (4)
With the "OK" key you can confirm the set-
tings.
When the symbol
▼ or is shown in the digital
indication, you can switch to the lower menu
level with the "OK" key.
The symbol indicates there is no branching
point below the menu item, but only a further
menu item of the respective function.
"ESC" key (3)
With the "ESC" key (Escape) you can inter-
rupt an adjustment or a current function or
switch to the next higher menu level.
To reach e.g. the uppermost menu level,
push the "ESC" key several times.
"+" and "–" key (2)
With the "+" and "–" keys you can modify the
values of the parameters or choose from a
number of options.
After an initial push, the value to be adjusted
flashes. Each additional push changes the
value.
Arrow keys (5)
With the keys "–>" and "<–", you can move
within the menu level from one menu item to
the next.
Digital indication (1)
During operation, the digital display shows
the actual measured value.
When adjusting the instrument, the clear text
display shows the respective function.
▼ Branching point, from where you can
move to the next lower menu.
This symbol informs you of a subsequent
safety enquiry.
Adjustment steps
On the following pages, you will see the menu
schematic of the adjustment module
MINICOM.
Set up the sensor in the following sequence.
The numbers correspond to the sequence of
the setup. You will find the numbers with the
respective menu items in the menu schematic
on the following pages.
1. Adjustment
2. Conditioning
3. Outputs
4. Operating range
5. Measuring conditions
6. Indication of the useful signal and noise
level
▼
▼
▼
▼