beautypg.com

Telephone operation – VTech CTM-S242SD Manual User Manual

Page 69

background image

65

Telephone operation

SIP classic cordless 2-line - S1420

Telephone operation

Conference call

This telephone allows three-way conversations.
To

initiate a conference call:

Place a call to the first party.
Press

HOLD to place the first party on hold.

Place a second call on the other line.
Once the second party is on the line, press

CONF to start a three-way conference.

To initiate a conference call while both calls are on hold:
Press

CONF to start a three-way conference.

To switch a conference call from the telephone base to the cordless handset:

During a conference call on the telephone base, press

/SPEAKER or CONF on the cordless handset.

During a conference call on the telephone base, press

HOLD on the telephone base and then press CONF on the

cordless handset.

To switch a conference call from the cordless handset to the telephone base:

During a conference call on the cordless handset, press

/SPEAKER or CONF on the telephone base.

During a conference call on the cordless handset, press

HOLD on the cordless handset and then press CONF on the

telephone base.

To end a conference call:

When the conference call is in speakerphone mode, press

CONF or /SPEAKER to end.

When the conference call is in handset earpiece mode, press

OFF on the cordless handset or place the cordless handset back

in the telephone base to end.
When there is more than one handset on the conference call, the call ends when all telephones hang up.

Find handset

Use this feature to find all registered cordless handsets.
To start paging:
Press

/FIND HANDSET on the telephone base when the phone is not in use. All idle cordless handsets beep for 60 seconds.

To end paging:

Press

/FIND HANDSET again on the telephone base.

-OR-

Press any key on the cordless handset to stop the paging tone.

Computer port
You can route your computer through the

COMPUTER port (RJ-45) on the side of the telephone base to get Internet access.

USB port
The

port on the side of the telephone base can be used for charging devices (up to 500mA @ 5V). Charging will be suspended

when there is an incoming call or the telephone is in use.

1.
2.
3.
4.