VTech CS6649_-2-3 Abridged manual - Manual (Page 3)

3
Tabletop to wall mount installation
The telephone comes ready for tabletop use. Follow the steps below to mount your
telephone on a wall.
Route the telephone line cord
through the cavity and leave a few
inches for plugging into the telephone
wall jack. Press the wall mount
bracket onto the telephone base until
it clicks into place.
3.
Squeeze the tabs on the wall mount
bracket as the arrows indicated below.
Swivel the wall mount bracket down.
2. Unplug the power adapter and
telephone line from the wall outlets.
Remove the power adapter and
telephone line from the grooves.
.
Put the corded handset aside. Press
down the switch hook and remove
the handset tab from the slot. Rotate
the handset tab by 80 degrees.
Press down the switch hook and then
replace the handset tab to its slot.
4.
Handset battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below). For best performance, keep the handset in the handset charger
when not in use. The battery is fully charged after hours of continuous charging.
Battery indicators Battery status Action
The screen is blank, or
shows Put in charger and
flashes.
The battery has no charge
or very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
flashes.
The battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
handset charger when not
in use.
Switch hook
Handset tab
Handset battery installation
Install the battery as shown below.
Slide the battery compartment cover
towards the center of the handset
until it clicks into place.
3. Place the handset in the handset
charger to charge.
4.
Plug the battery connector securely
into the socket.
. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
2.
CHARGE light
remains on
when charging.